Running The Installation; Installing The Printer Driver When Connected Via Usb Or Ieee1284 - SATO CL4NX Plus Driver Manual

1.3

Running the Installation

The printer driver installation procedure differs depending on how the computer and product are
connected.
Check how the product is connected before running the installation.
The printer driver installer is the same as other models. Ports that are not supported by the product
may be shown. Read this manual carefully and check the port to be used.
1.3.1

Installing the Printer Driver When Connected via USB or IEEE1284

This section describes how the printer driver is installed automatically with the Plug and Play feature.
Note:
 Automatic printer detection is supported only on a USB port and IEEE1284 port.
 Before starting the installation, close all applications.
 When you perform the printer driver setup, the properties settings, or the print settings, log in with
Administrator Privileges.
 When you use the printer driver, enable bi-directional communication.
 If the terminal service is being started with Windows Server 2008, change the terminal service to the
installation mode. However, it is not guaranteed that the printer driver can be used in the terminal service
environment.
 When using multiple products, it is necessary to install as many printer drivers as products, to identify each
product.
 After installing the printer driver for the first product, the printer driver for the second and additional products
will be automatically installed when the products are connected to the computer and powered on. However,
the names of the printer drivers will be " printer driver name (1)", "printer driver name (2)" etc. To change the
printer driver name, right-click the printer driver in [Devices and Printers], select [Printer properties], and
change the name at the top of the [General] tab.
1. Power on the product.
2. Connect the product to a computer, using a USB cable or IEEE1284 cable.
The printer driver is located online and downloaded to the computer. Automatic installation starts
immediately.
If the Printer Driver Is Available at the Windows Update Site (Automatic Installation)
On the latest operating systems (Windows 7 and later), a system notification message is shown. If
you click the notification message, the new [Driver Software Installation] dialog box opens. Monitor
the installation status, using this dialog box. Closing the dialog box finishes the installation.
If the Printer Driver Is Unavailable at the Windows Update Site (Manual Installation)
If the printer driver is unavailable at the Windows Update site, the connected product will be
recognized as "Other devices". Download the printer driver to the local disk. Select this product at the
SATO download site (www.satoworldwide.com/software/gallerydriver.aspx) and download "Printer
Driver".
Follow these steps to install the printer driver using the [Update driver] procedure.
11