Media Loading; Label Stock Loading - SATO M-84Pro Series Quick Manual

M-84PRO Quick Guide

Media Loading

Label Stock Loading

1. Open the Top Access Door by swinging it up
and to the left. Open the Side Access Door by
swinging it to rear of the printer.
2. Open the Print Head Assembly by pushing the
Head Latch towards the rear of the printer. The
Print Head Assembly is spring-loaded and will
automatically open as soon as the Head Latch is
disengaged.
3. Loosen the Label Edge Guide and push it to the
outside of the printer to give the maximum label
width.
4. Remove the Label Roll Guide.
Pg 5 M-84PRO Quick Guide
ERROR Signals
LED LCD
Message
Error Machine
On Error
Error EEPROM
On Error
Error Head
On Error
Error Sensor
On Error
Error Card R/W
Blinks Error
Error Card Low
Blinks Battery
Error Card No
Blinks Battery
Errors Head
Blinks Open
Error Cutter
Blinks Error
Error Parity
On Error
Line
Blinks
Error Overrun
On Error
Line
Blinks
Error Framing
On Error
Line
Blinks
Error Buffer
On Over
Line
Blinks
Error Paper End
Blinks
Audible Error
Beep Condition
1 Long Machine 1. Defective Board
Error
1 Long EEPROM 1. EEPROM not installed correctly
Read/Write 2. Overwriting EEPROM
1 Long Head 1. Electrical head malfunction
3 Short Sensor 1. Paper jam
2. Sensor DSW setting
3. Sensor level adjustment
1 Long Memory 1. Card not formatted
Card 2. No card recognized
Read/Write
1 Long Memory card 1. Card battery needs adjustment
Battery Low
1 Long No Battery in 1. Card needs battery installed
Card
3 Short Head Open 1. Head not latched
2. Head latch switch bad
3 Short Cutter 1. Cutter jam
2. Cutter sensor dirty
3 Short RS232 Parity 1. RS232 parameter mismatch
Error
3 Short RS232 1. RS232 parameter mismatch
Overrun
Error
3 Short RS232 1. RS232 parameter
Framing
Error
3 Short Buffer 1. Command stream exceeds buffer
Overflow size
3 Short Media End 1. No Paper
2. Paper incorrectly loaded
Pg 18
Possible Causes