Changing An Optical Drive Id - HP Surestore 80ex - Optical Jukebox User Manual

CAUTION
Do not turn off power to the jukebox until you are sure the SCSI bus is inactive.
Removing power from a SCSI peripheral when the bus is active can result in data
loss and/or indeterminate bus states. Check your host system manuals for
information about checking the SCSI bus status. If your computer is connected to a
LAN, be sure to check with your system administrator before turning off power to
the jukebox.

Changing an Optical Drive ID

Start with READY in the display.
1. Press
2. Press
3. Press
4. Press
5. Press
6. Press
7. Press
NOTE CONFLICT displays if you attempt to set the jukebox controller and a drive to the
same ID. Repeat the procedure and reset one of the IDs to another, non-conflicting
ID.
NOTE
After you change an ID you may have to restart your host computer for the new ID
to be recognized.
CAUTION Do not turn off power to the jukebox until you are sure the SCSI bus is inactive.
Removing power from a SCSI peripheral when the bus is active can result in data
loss and/or indeterminate bus states. Check your host system manuals for
information about checking the SCSI bus status. If your computer is connected to a
LAN, be sure to check with your system administrator before turning off power to
the jukebox.
Chapter 3
until SCSI ID * displays.
NEXT
. AC ID * displays. ("AC" is the "jukebox controller.")
ENTER
until DRV 1 ID * or DRV 2 ID * (if your jukebox has two
NEXT
drives) displays.
. DRV # ID? displays, where "#" is the number of the drive you
ENTER
selected in step 3 and "?" is the ID to which your selected drive is currently set.
until the ID you want displays.
NEXT
. SET # (# is a number from 0-7) displays briefly and then DRV #
ENTER
ID # displays again. The ID you chose is now set.
two times to return to the READY state.
CANCEL
Operating the Jukebox
Changing SCSI IDs
3-19