Ejecting An Optical Disk From The Jukebox; Setting A New Security Code - HP Surestore 80ex - Optical Jukebox User Manual

NOTE
Operating the Jukebox
Using the Front Panel Features
After the disk has been loaded into the selected storage slot,
3.
displays.

Ejecting an Optical Disk From the Jukebox

Start with READY in the display.
1. Press until EJECT * displays.
NEXT
2. Press . SLOT ## displays. ("##'' is a slot number from 1-16 where a disk
ENTER
is stored.
DRIVE # may also display, indicating there is a disk in a drive.)
3. If the number of the slot (or drive) that is displayed is the one you want, press
.
ENTER
If you want a different numbered slot (or drive), press
number displays. Then press

Setting a New Security Code

The security code 0 0 0 is set at the factory. This code is used when accessing and
setting jukebox configurations. Consider changing the security code so that only
authorized persons can change the configurations.
Don't forget your security code. If you forget it, only your service representative can
reset the security code to the factory setting so you can set a new code.
Start with READY in the display.
1. Press until CONF * displays
NEXT
2. Press . CONF 0 and a flashing 0 displays.
ENTER
3. Press until CONF 17 displays.
NEXT
Starting from when you press
the current security code.
4. Press . CODE 1 and a flashing 0 displays.
ENTER
5. Press until the first number of your current security code displays.
NEXT
6. Press . CODE 2 and a flashing 0 displays.
ENTER
7. Press until the second number of your current security code displays.
NEXT
8. Press . CODE 3 and a flashing 0 displays.
ENTER
3-10
.
ENTER
in the next step, you are prompted to enter
ENTER
READY
or until that
NEXT PREV
Chapter 3