HP StorageWorks XP512 - Disk Array Manual page 28

Caution
28
through which interconnecting cables can be run conveniently and
unobtrusively, and allows optimum distribution of conditioned air. Raised
floor access ramps must not exceed 10 slope
To estimate floor strength, the following items should be considered:
• The total weight of the equipment (the unpacked and packaged
weights are listed in this chapter)
• The total weight of furniture such as desks, chairs, and storage
cabinets
• Total approximate weight of computer room personnel
• Weight of moving equipment such as forklifts, dollies, and so on.
Any questions regarding the adequacy of airflow construction should be
referred to and evaluated by a qualified structural engineer.
In addition to determining the adequacy of the computer site floor, ensure
that all floors, stairs, and elevators which might be used when the disk
array is moved to its destination can support the weight and size of the
equipment. Failure to comply can result in damage to the equipment.
Maximum point floor loading is 500kg (1102.3 lbs). The minimum service
access is:
rear: 800m (31.5 in)
side: 0 mm
front: 800m (31.5 in)
HP SureStore E Disk Array XP512: Site Prep Guide