Setting The Host Mode For The Disk Array Ports - HP StorageWorks XP48 - Disk Array Configuration Manual
Disk array xp operating system configuration guide
Hide thumbs
Also See for StorageWorks XP48 - Disk Array:
- Owner's manual (124 pages) ,
- Configuration manual (72 pages) ,
- Manual (60 pages)
Table of Contents
Advertisement
Setting the Host Mode for the disk array ports
Installation
The disk array ports have Host Modes that you must set depending on the
host you use. After the disk array is installed, use Command View (shown)
or LUN Configuration Manager to set the Host Mode for each port.
The host mode setting for DYNIX/ptx is 04.
17
Advertisement
Table of Contents
