Install And Configure The Disk Array; Setting The Host Mode For The Disk Array Ports - HP XP1024 System Configuration Manual

Install and configure the disk array
The HP service representative performs these tasks:
• Assembling hardware and installing software
• Loading the microcode updates
• Installing and formatting devices
After these tasks are finished, you will use Remote Web Console, Command View,
Command View XP Advanced Edition, or LUN Configuration and Security Manager to
complete the remaining tasks listed below. If you do not have these programs, your HP
service representative can perform these tasks for you.

Setting the host mode for the disk array ports

After the disk array is installed, you must set the host mode for each disk array port to
match the host OS. Set the host mode using LUN Manager in Remote Web Console
XP (shown), Command View XP, or Command View XP Advanced Edition. If these are
not available, the HP service representative can set the host mode using the SVP. The
host mode for AIX is 0F.
Disk Array XP operating system configuration guide: IBM AIX
13