Setting The Host Mode And Host Group Mode For The Disk Array Ports; Host Mode Settings; Volume Names For Host Mode Setting - HP StorageWorks XP10000 - Disk Array Configuration Manual

Assembling hardware and installing software
Loading the microcode updates
Installing and formatting devices
After these tasks are finished, you will use XP Remote Web Console, XP Command View Advanced
Edition Software, or XP Array Manager to complete the remaining tasks listed below. If you do not
have these programs, your HP service representative can perform these tasks for you.

Setting the host mode and host group mode for the disk array ports

After the disk array is installed, you must set the host mode for each host group that is configured on
a disk array port to match the host OS. Set the host mode using LUN Manager in XP Remote Web
Console (shown) or XP Command View Advanced Edition Software. If these are not available, the
HP service representative can set the host mode using the SVP.
The available host mode settings are as follows:
Table 1 Host mode settings
Host mode
2C (available on some array mod-
els)
0C
Table 2 Volume names for host mode setting
Volume on XP array (examples)
OPEN-E
OPEN-9
OPEN-9*2
OPEN-9*3-CVS
10 Installing and configuring Windows for the XP disk array
Description
HP recommended. (For use with LUSE volumes when online LUN
expansion is required or may be required in the future.)
HP recommended. (Use if future online LUN expansion is not
required or planned.)
Volume name as seen on host
host mode = 0C
OPEN-E
OPEN-9
OPEN-9*2
OPEN-9*3-CVS
host mode = 2C
OPEN-E
OPEN-9
OPEN-9
OPEN-9-CVS