Install And Configure The Disk Array; Setting The Host Mode For The Disk Array Ports - HP XP1024 System Configuration Manual

Install and configure the disk array
The HP service representative performs these tasks:
• Assembling hardware and installing software
• Loading the microcode updates
• Installing and formatting devices
After these tasks are finished, use Remote Web Console, Command View, Command
View XP Advanced Edition, or LUN Configuration and Security Manager to complete
the remaining tasks listed below. If you do not have these programs, your HP service
representative can perform these tasks for you.

Setting the host mode for the disk array ports

After the disk array is installed, you must set the host mode for each disk array port to
match the host OS. Set the host mode using LUN Manager in Remote Web Console XP
(shown), Command View XP, or Command View XP Advanced Edition. If these are not
available, the HP service representative can set the host mode using the SVP.
Disk Array XP operating system configuration guide: Windows 2000/2003
13