Epson STYLUS PRO 7700 User Manual page 180

180 | Solving Problems
Message
NOZZLE CLOG DETECTED
NOT ENOUGH EMPTY
SPACE IN MAINT TANK
CONTINUE CLEANING?
YES (RECOMMENDED)
NO
PAPER CUT ERROR
REMOVE UNCUT PAPER
PAPER EJECT ERROR
REMOVE PAPER FROM
PRINTER
PAPER ERROR
LOAD PAPER CORRECTLY
PAPER JAM
REMOVE PAPER
PAPER LOW
PAPER OUT
LOAD PAPER
PAPER RELEASED
LOAD PAPER
PAPER SENSOR ERROR
PRESS THE BUTTON
LOAD DIFFERENT PAPER
PAPER SETTING ERROR
CHECK THE PAPER SOURCE
IN THE DRIVER SETTINGS
AND LOAD PAPER
CORRECTLY
Explanation
There is not enough space in
the maintenance tank to
perform cleaning.
Roll paper was not cut
correctly.
The cutter may be blunt or
incorrectly installed.
Roll paper is used with the cut
sheet setting.
Paper is not loaded correctly.
Paper has jammed in the
printer.
The paper roll is almost
finished.
No paper is loaded.
The button has been
pressed with no paper loaded.
Paper ran out during printing.
The button has been
pressed.
The paper is not detected.
The paper source selected in
the printer driver and the
control panel do not match.
180
Response
Select YES, then follow the instructions to
replace the maintenance tank.
Press the button and open the front
cover. Remove the uncut paper.
Reinstall or replace the cutter if necessary;
see page 162.
Press the button and remove the paper.
Press the button, then reload paper
correctly.
Press the button and remove the
jammed paper; see page 191 for more
information.
Replace the roll.
Load paper.
Press the button, then load paper.
Press the button and remove the roll
paper core. Then load another roll.
Load paper, then press the
Press to clear the error, then select
the right paper.
Check the Paper Source or Paper Size
settings and make sure the paper is loaded
correctly.
button.