Setting Up Automatic Media Tracking And Identification - Epson STYLUS PRO 7700 User Manual

Tip: You can use
Maintenance mode to
switch the units of
measurement in the
printer from meters to
feet. See page 162 for
instructions.

Setting Up Automatic Media Tracking and Identification

Before you load roll paper in the printer, you can set up the automatic media
tracking system. This system prints a barcode on the edge of the paper that
indicates the media type, roll length, and the alert setting.
When the printer is turned on or roll paper is placed in the printer, the
barcode is scanned and the amount of roll paper remaining is displayed on
the LCD panel. You will see an alert message when the roll is nearly used up.
The barcode is printed when you press the
button.
Make sure
PAPER OUT
steps to set up the automatic media tracking system:
1. Press r .
Menu
2. Press u or d to select
3. Press r to select
ROLL PAPER REMAINING
4. Press r to select
REMAINING PPR SETUP
5. Press d, select
ON
6. Press l to go back to
7. Press d to select
ROLL PAPER LENGTH
8. Press r, then select the length of the roll paper loaded in the printer,
from 15 to 300 ft (5 to 99.5 m), then press
9. Press l, then press d to select
10. Press r, then select the length at which you want to receive an alert
message, from 3 to 50 ft (1 to 15 m), then press
11. Press to exit the menu.
Handling Paper and Other Media
appears on the control panel. Then follow these
, then press r.
PAPER SETUP
, and press .
OK
REMAINING PPR SETUP
ROLL LENGTH ALERT
61
Paper release (ePlaten)
.
.
.
.
.
OK
.
.
OK
| 61