HP StorageWorks P9000 - Disk Arrays User Manual page 113

Table 19 RAID Manager error codes for Continuous Access Journal (continued)
Error code (SSB1) Error code (SSB2)
8F35
8F39
8F46
8F47
8F4D
8F50
8F53
8F58
8F67
8F6D
8F6E
8FEC
B992
B9C0
B9E1 B901
Error content
The following programs for OPEN systems might not be installed, or the
licenses of them might be expired. Please confirm settings for:
Continuous Access Synchronous
Continuous Access Journal
A request of Cnt Ac-J pair create was rejected because the program product
of Cnt Ac-J was not installed.
The Cnt Ac-J pair cannot be created because cache CL2 is in abnormal
status.
The Cnt Ac-J pair cannot be created because cache CL1 is in abnormal
status.
The Cnt Ac-J pair cannot be created or resynchronized due to the following
contributing factors:
Secondary journal is not registered.
Secondary journal volume is being blocked.
The specified S-VOL is being blocked.
A request of Cnt Ac-J Paircreate or Pairresync was received. However, the
operation cannot be performed because the load of the processing was
high. Wait about 5 minutes, then retry the operation.
A request of Cnt Ac-J Paircreate was rejected because the status of the
configuration could not be transited.
A request of Cnt Ac-J Paircreate or Pairresync was rejected because of the
one of following reasons.
The pair status of the specified S-VOL differed from the one of P-VOL.
The state of restore journal differed from the state of master journal.
A request of Cnt Ac-J Paircreate was rejected because the specified
secondary system did not support the external volume.
A request of Cnt Ac-J Paircreate was rejected because the specified volume
was a command device.
The Cnt Ac-J pair cannot be created because the P-VOL is a volume for the
Just in Time function.
The Cnt Ac-J pair cannot be created because the P-VOL is being used for
Snapshot.
The information of the consistency group cannot be retrieved, because
Continuous Access Journal was not installed.
The source of command devise has run out. Set to OFF the command device
and to ON again from the LUN Manager.
Cnt Ac-J Paircreate cannot be performed because the specified device is a
command device.
Troubleshooting using RAID Manager 1 13