Hard Drive - HP CQ58-300 Maintenance And Service Manual

Hard drive

NOTE: The hard drive spare part kit does not include the hard drive bracket, hard drive connector
cable, or screws.
Description
750-GB, 5400-rpm, 9.5-mm
640-GB, 5400-rpm, 9.5-mm
500-GB, 5400-rpm, 9.5-mm
320-GB, 5400-rpm, 9.5-mm
Hard Drive Hardware Kit (includes hard drive bracket, hard drive connector cable, and screws)
Before removing the hard drive, follow these steps:
1. Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn
the computer on, and then shut it down through the operating system.
2. Disconnect the power from the computer by unplugging the power cord from the computer.
3. Disconnect all external devices from the computer.
4. Remove the battery (see
5. Remove the memory module/wireless module compartment cover (see
on page
Remove the hard drive:
1. Loosen the captive screw (1) that secures the hard drive compartment cover to the computer.
2.
Lift the rear edge of the hard drive compartment cover (2) up and forward until it rests at
an angle.
Battery on page
41).
40).
Component replacement procedures
Spare part number
634250-001
669300-001
669299-001
622643-001
686261-001
Memory module
51