Power Connector Cable - HP CQ58-300 Maintenance And Service Manual

c. Remove the wireless antenna cables and transceivers (3). The wireless antenna cables and
transceivers are available using spare part number 686249-001.
Reverse this procedure to install the display assembly.

Power connector cable

Description
Power connector cable (includes bracket)
Before removing the power connector cable, follow these steps:
1. Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn
the computer on, and then shut it down through the operating system.
2. Disconnect the power from the computer by unplugging the power cord from the computer.
3. Disconnect all external devices from the computer.
4. Remove the battery (see
a. Memory module/wireless module compartment cover (see
b. Keyboard (see
c. Hard drive (see
d. Top cover (see
e. Display assembly (see
Remove the power connector cable:
1. Disconnect the power connector cable (1) from the system board.
2. Remove the Phillips PM2.5×6.5 screw (2) that secures the power connector and bracket to
the base enclosure.
Battery on page 40), and then remove the following components:
Keyboard on page 45)
Hard drive on page 51)
Top cover on page 55)
Display assembly on page
Spare part number
686258-001
Memory module on page
76)
Component replacement procedures
41)
85