How To Use The Pulse Sensor - Image 10.6 Owner's Manual

HOW TO USE THE PULSE SENSOR
The treadmill features a state-of-theft cordless pulse
sensor, specially designed for greater acoumcy, com-
fort, and durability. Please read the foflowing
Instructions before using the pulse sensor.
HOW TO INSTALL BAI-I'ERIES
The pulse sensor requires two "AAA" batteries.
Alkaline batteries are recommended. To Install batter-
ies, first slide off the battery cover as shown below.
forehead, and that the_ is_o,'l_iL,_be_e_n the sensor
wlndow and your forehead.;
Window
__ _' Batteries
Note the markings inside the battery comp=lment
showing which direction batteries must be tumed.
Insert two "AAA" batteries into the battery compart-
ment. Replace the battery cover.
HOW TO ADJUST THE HEADBAND
For the pulse sensor to function properly, the head-
band must fit snugly around your head, without being
uncomfortable. To adjust the headband, insert the
aajustment
tab through
the appropri-
ate hole in
the head-
band. Note:_
Each time
you exer-
cise, the
headband
may expand
sllghtly dur-
ing the first
few minutes
Adjustment_,.._
of use. It may be necessary to readjust the head-
band periodically.
HOW TO PUT ON THE PULSE SENSOR
Rub your forehead briefly to stimulate circulation. Put
on the headband as shown at the top of this page.
Make sure that the sensor window is centered on your
PROPER ORIENTATION OFTHE PULSE SENSOR
The transmitter on the pulse sensor is angled down-
ward, as shown below. For the pulse sensor to func-
tion properly, the transmitter must be pointed within
30 ° of the center of the console (the shaded area in
the drawing). If you tum your head too far away from
the console, the signal from the pulse sensor will not
be received.
Pulse Sensor
GUIDELINES FOR OBTAINING ACCURATE PULSE
READINGS
The instructions on page 11 explain how the pulse
sensor is used with the console (see HOW TO USE
THE PULSE DISPLAY). For the bast.results, remem-
ber the following important guidelines: °
1. Before putting on the headband, rub your forehead
for a moment to stimulate circulation.
2. Make sure that the headband fits snugly around
your head, without being uncomfortable. If the
headband is too loose or too tight, your pulse may
not be detected.