Image 10.6 Owner's Manual page 6

5. PlugthelowerendoftheUpright WireHarness ( 12)into
the
20" Wire Harness (45). The small latch on the Upright Wire
Harness should snap onto the 20" Wire Harness (see the
upper inset drawing). If the Wire Hamesees do not fit together
easily, turn them; do not force the Wire Harnesses together.
Slide the ends of the 12"Cable Looms (36) against the ends of
the Wire Hamesses (12, 45) (see the lower inset drawing). Be
careful not to damage the Wire Harnesses.
12
6. Press the Belt Tool (86) into the opening in the Left Rear
Endcap (82). The use of the Belt Tool is explained on page 21.
7. Attach the Pulse Sensor (14) to one of the Headbands (93 or
107). Make sure that the sensor window is pressed through
the indicated hole in the Headband.
The use of the pulse sensor is explained on pages 7 and 8.
7
Sensor 93 or 107
Window
Make sure that all pads are tightened before you use the treadmill. The use of all remaining parts will be
explained in other sections of this manual. Note: To protect the floor or carpet from damage, place a mat
under the treadmifl.
6