Image 10.6 Owner's Manual page 5

ASSEMBLY
Assembly requlrea two paople_ Set the treadmill in a cleared area and remove _II _l_att_da_. Do not
dispose of the packing materials until the treadmill is fully assembled.
Assembly can be completed using the Included 7/32" allen wrench
1. Find the Right Upright (15), which contains the Upright Wire
Harness (12) (see the inset drawing). Hold an Updght Spacer
(25) inside the lower end of the Right Upright. Insert a 3/8" x
3 1/2" Bolt (27), with one of the four Upright Washers (26), into
the lower hole in the Right Updght, and through the Upright
Spacer. Slide a Star Washer (49) onto the Bolt. Finger tighten
the Bolt into the indicated hole in the Frame (50).
Insert a 3/8" x 3 1/2" Bolt (27), with an Upright Washer (26),
through the other hole in the lower end of the Right Upright (15).
Finger tighten the Bolt into the Frame (50).
Attach the Left Upright (not shown) in the same manner.
26 27
2. Hold the right end of the Console Crossbar (6) near the Right
Upright (15). Connect the Console Wire Harness (10) to the
Upright Wire Hamess (12). The small latch on the Console
Wire Harness should snap onto the Upright Wire Hamess (see
the inset drawing), ff the Wire Hamesses do not fit together
easily, tum them; do not force the Wire Hamesses together.
Slide the end_ of the 6" Cable Looms (30) against the ends of
the Wire Harnesses (10, 12). Insert the Cable Looms into the
Right Upright (15). Be careful not to damage the Wire
Harnesses.
2
10
12
_0
3. Slide the ends of the Console Crossbar (6) into the Right and
Left Uprights (15, 2) as shown. Insert a Console Knob (3) into
each Upright, and thread the Console Knobs into the ends of
the Console Crossbar. Rotate the Console (9) to the desired
angle, and tighten the Console Knobs.
3
15
4_oTap an Upright Endcap (4) into each of the Uprights (15, 2).
See assembly step 1. Using.the included 7/32" allen wrench,
tighten the four 3/8" x 3 1/2" Bolts (27).