Table of Contents
Advertisement
Operation
Use the Date/Time Setup screen to set and display the date and time information.
Set Unit Label
Use following steps to display Unit Label Setup screen on the OSD menu:
1. Navigate to the Unit Setup screen, see Unit Setup screen on page 23.
2. Press the down arrow button to select Unit Label .
3. Press Enter .
4. When the six-character label is selected, use the up/down and left/right buttons to set
Switch Application (to different software version)
Use following steps to display Application Switch screen on the OSD menu:
1. Navigate to the Unit Setup screen, see Unit Setup screen on page 23.
2. Press the down arrow button to select Switch Application .
3. View the details as shown in Figure 3.21 .
4. Use the Application Switch to run a backup version of the software on the unit. Upon
30
Figure 3.20: iPump 562 OSD Date/Time Setup
Table 3.13: Date and Time Information Settings
Option
Current Date
Current Time
Time zone
DST
to a desired label. Press Enter to save the change. Use the left arrow button to go to
the previous menu level.
selecting the Backup Software by pressing Enter , the system restarts with the
different software which is labeled as current. The previously run software is labeled
800092-01 Rev. A
Possible values
Yyyy/mm/dd
Hh:mm:ss
All available...
Yes / No
www.wegener.com
Advertisement
Table of Contents
