Table of Contents
Advertisement
Operation
LAN IP Networking
Carrier Settings
Terminal options
User Relay
Date and Time information
Unit Label settings
Switch Application
Set Video Decoder options
Set Decoder Options
Use following steps to display Decoder Setup screen on the OSD menu:
1. Navigate to the Unit Setup screen, see Unit Setup screen on page 23.
2. Press the down arrow button to select Decoder Setup .
3. View the details as shown in Figure 3.13 .
Use the Decoder Setup screen to set and display the decoder options.
Option
Decoder Source
TV Aspect Ratio
Output Scaling
Closed Captioning
24
Figure 3.13: iPump 562 OSD Decoder Setup
Table 3.7: Video Decoder Options
Possible values
Follow Tune (currently selected
RF source and program #) or Off
(no A/V output)
4x3 (Traditional TV) 16x9 (Wide
screen TV) 14x9 (CiniView II)
Letterbox (black bars either at
top/bottom or at sides), Pan/Scan
(display may be off screen)
PASSTHRU (ntsc/pal) or CC1:4
(EIA-608) orDTV (EIA-708-B)
800092-01 Rev. A
Comments
Controls source of input transport stream for the
primary A/V decoder to play. The source can be either
Multicast UDP from Satellite/RF or Multi/Unicast UDP
from LAN/ETHERNET
Allows the receiver to automatically correct a mismatch
in the aspect ratio of the TV to the content being
displayed.
Optimizes viewing quality if the content does not match
the TV Aspect Ratio. In Pan/Scan mode, improvement
in viewing experience depends on the source content.
Sets the option to render subtitling information in
different formats including Divicom.
www.wegener.com
Advertisement
Table of Contents
