Adjusting The Table Square To Head - Craftsman 113.213100 Owner's Manual

ADJUSTING THE TABLE SQUARE TO
HEAD
NOTE: The combination square must be "true." See
the beginning of the "Assembly" section for a method
to check four square.
1. Insert precision round steel rod or straight drill bit
approximately 3" long into chuck and tighten.
2. With table raised to working height and locked on
column, place combination square flat on table be-
side rod.
[ I
ROD
COMBINATION
SQUARE
3. If an adjustment is necessary, loosen the table
bevel lock bolt with adjustable wrench. (This adjust-
ment is located under the table).
4. Align the table square to the rod by tilting table.
5. Retighten table bevel lock bolt.
TABLE
BLE BEVEL
LOCK BOLT
14