Assembly; Assembly Of Base/Column; Installation Of Table/Support - Craftsman 113.213100 Owner's Manual

assembly
[
' WARNING: To avoid injury from unexpected
I starting or electrical shock, never connect plug
1 to outlet unti! aH assembly stepsare completed
and you read a!l instructions,
TOOLS NEEDED
COt_B_NATgON SQUARE
MEDIUM PHILLIPS
SCREWDRIVER
84NCH ADJUSTABLE
WRENCH
COMBINATgON SQUARE MUST BE TRUE.
Check ifts accuracy as Uiustrated below.
DRAW LIGHT
L_NE ON BOARD
A LONG THIS EDGE___._,I___/__;_'
SHOULD BE NO GAP OR OVERLAP WHEN
SQUARE iS FLIPPED OVER IN DOTTED POSIT_ON
STRAIGHT EDGE OF
BOARD 3/4' THICK
";'HIS EDGE MUST BE
PERFECTLY STRAIGHT
8ram DIA x 20ram LONG BOLT
ASSEMBLY OF BASE/COLUMN
I, Position base on floor, Remove protective covering
and discard
2, Remove protective sleeve flora coiumn tube and
discard, PIace column assembiy on base, and align
holes in column support with holes in base,
3, Locate three (3) 8ram Dia, x 20ram tong bolts
among loose pa_ts bag.
4, tnsta!l abott in each hole through column support
and base and tighten with adjustable wrench,
\ BASE
COL..UMN
_'-- ASSEMBLY
INSTALLATION OF TABLE/SUPPORT
ASSEMBLY AND HARDWARE
I. Locate tabte!suppod as,_;mb y
2. Slide table/support assembly onto cotumn. Position
directiy above base.
BASE
COLUMN
TABLE/SUPPORT
ASSEMBLY
10