Installing Light Bulb; Adjusting The Table Square To Head; Adjusting The Pointer - Craftsman 113.213853 Owner's Manual

INSTALLING LIGHT BULB
1. Install a light bulb (not larger than 60 watt) into the
socket inside the head.
ADJUSTING THE TABLE SQUARE TO HEAD
NOTE: The combination square must be "true". See
"Unpacking and Checking Contents" section for
method.
.
2.
Insert a precision ground steel rod approximately 3"
long into chuck and tighten.
With table raised to working height and locked on
column, place combination square flat on table be-
side rod.
,
.
5.
6.
If an adjustment is necessary, loosen the set screw
under bevel lock with 1/8" HEX "L" wrench, then
loosen the table bevel lock with adjustable wrench.
(These adjustments are located under the table).
Align the table square to the rod by tilting arm until
square and rod are in line.
Retighten table bevel lock.
Retighten set screw.
ARM
" / _7_ TABLE
TABLE L....L-.--- BEVEL
_J LOCK
SET
SCREW
ADJUSTING POINTER
1. With the table squared to the head, the table bevel
pointer should be adjusted.
2. Loosen screw in pointer with screwdriver, and move
pointer to "0" position on scale. Retighten screw.
TABLE
SCALE
SCREW
POINTER
13