Installing Feed Handles; Installing The Chuck - Craftsman 113.213100 Owner's Manual

iNSTALLiNG FEED HANDLES
1. Locate three (3) feed handles among loose parts.
2. Screw the feed handles tightly into the threaded
holes in the hub. FEED
HANDLE
\
HUB
INSTALMNG THE CHUCK
1. Locate the chuck among loose parts.
2. Clean out the TAPERED HOLE in the chuck; clean
the spindle nose with a clean cloth. Make sure
there are no foreign particles sticking to the sur-
faces. The slightest piece of dirt on the spindle
nose or in the chuck will prevent the chuck from
seating properly. This will cause the drill to
"wobble."
NOTE: If TAPERED HOLE in the chuck is ex-
tremely dirty, use a cleaning solvent on the clean
cloth,
CHUCK
3. Push the chuck up on the spindle nose as far as
it will go.
4. Turn chuck sleeve clockwise and open jaws in
chuck completely,
5. Lightly tap the nose of the chuck with a piece of
wood to insure proper seating of the chuck on the
spindle.
_ SPINDLE
NOSE
CHUCK
12