Install The Lights; Attach The Emergency Release Rope And Handle - Craftsman 139.30437 Owner's Manual

INSTALLATION STEP 6
Install the Lights
1. Press the releasetabs on both sides of lens. Gently rotate lens
back and downward until the lens hinge is in the fully open
position. Do not remove the lens.
2. Insert an A19 incandescent or compact fluorescent light bulb
(100 watt maximum), into the light socket. The lights will turn
ON and remain lit for approximately 4-1/2 minutes when power
is connected. Then the lights will turn OFF.
3. Reversethe procedure to close the lens.
4. If the bulbs burn out prematurely due to vibration, replacewith
a garage door opener bulb. Use A19, standard neck garage
door opener for replacement.
NOTE: Use only standard light bulbs. The use of short neck or
speciality light bulbs may overheat the endpanel or light socket.
To prevent possible OVERHEATING of the end panel or light
socket:
• Use ONLYA19 incandescent or compact fluorescent
light bulbs.
• DONOT use incandescent bulbs larger than 100W.
• DONOT use compact fluorescent light bulbs larger than
26W (100W) equivalent.
• DONOT use halogen bulbs.
• DONOT use short neck or specialty light bulbs.
Release Tab
Compact Fluorescent --
Light Bulb
or
100Watt(Max)
Standard Light Bulb
/
100 Watt (Max) \
Standard Light Bulb _
Hinge
Compact Fluorescent
Light Bulb
INSTALLATION STEP 7
Attach the Emergency Release Rope and Handle
1. Thread one end of the rope through the hole in the top of the
red handle so "NOTICE"reads right side up as shown. Secure
with an overhand knot at least 1" (2.5 cm) from the end of the
rope to prevent slipping.
2. Thread the other end of the rope through the hole in the
releasearm of the outer trolley.
3. Adjust rope length so the handle is 6 feet (1.83 m) above the
floor. Ensurethat the rope and handle clear the tops of all
vehicles to avoid entanglement. Secure with an overhand knot.
NOTE:If it is necessary to cut the rope, heat seal the cut end with
a match or lighter to prevent unraveling.
To prevent possible SERIOUSINJURYor DEATHfrom a falling
garage door:
• If possible, use emergency release handle to disengage
trolley ONLYwhen garage door is CLOSED.Weak or broken
springs or unbalanced door could result in an open door
falling rapidly and/or unexpectedly.
• NEVERuse emergency release handle unless garage
doorway is clear of persons and obstructions.
• NEVERuse handle to pull door open or closed. If rope knot
becomes untied, you could fall.
Trolley
Trolle
Release
Arm
Emergency
Release Handle
Overhand
Knot
17