Craftsman 139.3050 Quick Start Manual

Compatible with 315 MHz or 390 MHz garage door openers
manufactured after January 1, 1993. Make sure the garage door
opener has a working light bulb because it is a programming
indicator.
Refer to your product manual for the location of the Learn button.
Install the battery and program the Keyless Entry prior to
installation.
PREPARE
3
Enter a 4-digit
personal
identification
number (PIN)
of your choice:
? ? ? ?
To program the Keyless Entry to more than one garage door opener, repeat the steps above using a new PIN for each additional garage door opener.
CHANGE AN EXISTING PIN*
1
Press the programmed PIN 2
that you want to change.
? ? ? ?
* For garage door openers that have a green Learn button or an external receiver repeat "Program Initial PIN" to change the existing PIN.
To prevent possible SERIOUS INJURY or DEATH from a moving gate or garage door:
• Install Keyless Entry Control within sight of the garage door, out of reach of children at a minimum height of 5 feet (1.5 m), and
away from ALL moving parts of door.
• ALWAYS keep remote controls out of reach of children. NEVER permit children to operate, or play with remote controls.
• Activate gate or door ONLY when it can be seen clearly, is properly adjusted, and there are no obstructions to door travel.
• ALWAYS keep gate or garage door in sight until completely closed. NEVER permit anyone to cross path of moving gate or door.
Locate the Learn button on the garage door
opener.
NOTE: Your garage door opener may
look different.
Learn
LED
OR
Learn
LED
Green
or
Purple
Red/Orange
4
Press and release the ENTER
button...
Check to see if the
light bulb blinks.
If not, slowly press
and release the
ENTER button until
the light bulb blinks.
Be careful NOT to
press the ENTER button after
the light bulb blinks.
Press and hold the
# button until...
...the light bulb blinks twice.
PROGRAM INITIAL PIN
1
Learn
LED
OR
Yellow
5
3
Enter the new 4-digit PIN of your choice,
then press the ENTER button.
+
? ? ? ?
new PIN
WIRELESS KEYLESS ENTRY • MODEL 139.3050
2
Press and hold
the and #
*
buttons until
the lights on the
keypad stop
blinking.
Press 0 to 6 To test, press the PIN, then press the ENTER button.
complete the
programming.
? ? ? ?
+
PIN
The light bulb will blink once.
Press and
release the
Learn button.
The LED will light.
Within 30 seconds...
The garage door
opener will activate.
4
To test, press the new PIN,
then the ENTER button.
The garage door opener
will activate.