Motor Connections; Installing Feed Handles; Installing The Chuck - Craftsman 113.213213 Owner's Manual

MOTOR CONNECTIONS
plug to power source outlet until ag assembly
steps are completed.
1, Open motor connector box cover located on under-
side of motor using flat blade screwdriver.
WARNING: To avoid electrocution, never con-
nect anything but the ground wire (colored
green) to the green screw.
2. Remove GREEN SCREW and insert through round
metal terminal on the end of the GREEN wire of
power cord.
3. Reinsert GREEN SCREW in threaded hole that it
was removed from and tighten securely,
4. Insert terminal end of WHITE wire on spade terminal
(next to silver _ marked #4 on the motor. Push
terminal firmly until seated.
5. Insert terminal end of BLACK wire on spade terminal
(next to copper gp__) marked #1 on the motor. Push
terminal firmly until seated.
6. Close motor connector box being sure that power
cord is seated in the "center" strain relief groove and
tighten box cover screws.
7, Do not plug in power cable.
-/U(((( - CE.TER sT.*,.
-tt'_\\\ J]_'l_ _"1 _ RELIEF GROOVE
\'k._ _ _ _ F'_ \-"" TO TERMINAL #4
POWER
BLACK }LACK
GREEN
GROUND
MOTOR
CORD
1. Locate three (3)feed handles arnong loose parts. _ _,_,_,,_, /
2 Screw the feed handles into the threaded holes in _,,_
/_-'_ FEED
HANDLE
i
f
i
INSTALUNG THE CHUCK
1. Clean out the TAPERED HOLE in the chuck, Clean
the tapered surface on the arbor with a clean cloth,
Make sure there are no foreign particles sticking to
these surfaces. The slightest piece of dirt on these
surfaces will prevent the chuck from seating proper-
ly. This will cause the drill to '_Nobble" or possibly fall
off when drilling.
QUILL
ARBOR
CLEAN THIS
SURFACE
16