Motor Connections; Installing Feed Handles; Installing The Chuck - Craftsman 143.213150 Owner's Manual

MOTOR CONNECTIONS
WARNING: FOR YOUR OWN SAFETY, NEVER CON-
NECT PLUG TO POWER SOURCE OUTLET UNTIL
ALL ASSEMBLY STEPS ARE COMPLETED.
power cord.
3. Reinsert GREEN SCREW in threaded hole that it
was removed from and tighten securely.
4. Insert terminal end of WHITE wire on spade _ermi-
nal (next to silver post) marked #4 on the motor.
Push terminal firmly until seated.
5. Insert terminal end of BLACK wire on spade termi-
nal (next to copper post) marked # 1 on the motor.
Push terminal firmly until seated.
6. Close motor connector box being sure that power
cord is seated in strain relief groove and tighten
box cover screws.
BLACK WIRE TO
TERMINAL #1
COPPER POST
_,\V _",_ I1 ""_t_--_3. WHITE WIRE
MOTOR
.ow°. .o.o. oo.°w.,.;.
GREEN
(GROUND)
7. Do not plug in power cable.
INSTALLING FEED HANDLES
1. Locate three (3) feed handles amo'ng leose
parts.
2. Screw the feed handles into the threaded holes
inthe hub and tighten.
FEED
HANDLE
HUB
INSTALLING THE CHUCK
1. Ctean out the TAPERED HOLE in the chuck, Clean
the tapered surface on the arbor with a clean
cloth. Make sure there are no foreign particles stick-
ing to the surfaces. The slightest piece of dirt on
any of these surfaces will prevent the chuck from
seating properly. This wilt cause the drill to
"wobble."
14
CLEAN THIS
SURFACE
ARBOR