Table of Contents
Advertisement
MOUNTING
MOTOR
1. Locate four (4) 8mm Dia. x 20mm long hex head y
bolts, eight (8) flat washers, and four (4) hex nuts
among loose parts.
2. Put a fiat washer on each bolt.
3. Install hex head bolts through motor bracket on
head.
4. Place motor in position so motor base slots line up
with motor bracket slots. Install fiat washers and hex
nuts as illustrated. (Do not tighten)
5. Motor shaft should be as close as possible to center
of round opening in belt guard.
8mm Dia.x 2_m LONGBOLT
HEXNUT
FLAT WASHER
BOLT
INSTALLING
MOTOR PULLEY
1. Find the motor pulley in loose parts bag.
2. Slide pulley onto motor shaft. Line up the flat surface
on the motor shaft with the set screw in pulley.
3. Make sure the pulley does not rest on the lower
guard.
4. Tighten
the set screw using a "4" mm Hex "L"
wrench.
MOTOR
BRACKET
MOTOR
BASE
FLAT
HEX
WASHER
NUT
MOTOR
PULLEY
SET SCREW
FLAT
_
SURFACE
INSTALUNG
AND TENSIONING
BELT
WARNING: To avoid injury due to accidental
starting always turn drill press off and remove
switch key before making belt adjustments.
1. Place a straight edge such as a piece of wood,
metal, or framing square across the top of pulleys.
2. Move the motor upward until the pulleys are in line.
"13ghtenthe motor mount nuts using an adjustable
wrench.
NOTE: To avoid rattles or other noise, motor frame
must not touch lower belt guard.
3. Release Belt Tension Lock handles located on each
side of Drill Press head by turning them counter-
clockwise.
4. Loosen Belt Tension handle by turning clockwise.
STRAIGHT EDGE
t,
2
0001
LOWER
BELT
MOTOR
BELT
TENSION
MOUNT
MQTQR
GUARD
LOCK
NUTS
HANDLE
•
'_'
BELT
]
"__i
TENSION
HANDLE
Hide quick links:
Advertisement
Table of Contents
