Craftsman 315.212120 Owner's Manual page 15

Note: Many of the illustrationsin this manual show
only portionsof your compound miter saw. This is
intentionalso that we can clearly show points being
made in the illustrations.Never operate your saw
withoutall guards securely in place and in good
operating condition.
CUTTING A SLOT IN THE ZERO
CLEARANCE THROAT PLATE
In order to use your compound miter saw, you must
cut a slot through the zero clearance throat plate to
allow for blade clearance. To cut the slot, set your
saw at 0 degrees miter, turn sew on and allowthe
blade to roach full speed, then carefully make a
straightcut as far as it will go through the throat plate.
Turn your saw off and allow the blade to come to a
complete stop before raisingthe saw arm.
Next, adjust the bevel angle to 45 degrees, turn your
sew on and allow the blade to reach full speed, then
carefully make another cut through the zero clearance
throat plate. The throat plate will than be wide enough
to allow the blade to pass through it at any angle from
0 to 45 degrees.
SQUARING THE MITER TABLE
TO THE FENCE
See Figures 13 - 16.
• Unplug your saw.
_k WARNING: Failure to unplug your saw could
result in accidental starting causing possible
serious personal injury.
• Push down on the sew arm and pull out the lock
pin to release the sew arm.
• Raise saw arm to its full raised position.
• Loosen the miter lock handle approximatelyone-
half turn.
• Depress the miter lock plate and rotate the miter
table until the pointer on the controlarm is posi-
tioned at 0°.
Release the miter lock plate and securelytighten
the miter lock handle.
Lay a framing square flat on the miter table. Place
one leg of the square against the fence. Place the
other leg of the square beside the zero clearance
throat plate in the miter table. The edge of the
square and the zero clearance throat plate in
the miter table should be parallel as shown in
figure 13.
If the edge of the framing square and the zero
clearance throat plate in the miter table are not
parallel as shown in figures 14 and 15, adjust-
ments are needed.
FRAMING
SQUARE
FENCE
MITER TABLE r
ZERO CLEARANCE
THROAT PLATE
MITER
MITER LOCKHANDLE
LOCKPLATE
VIEWOFMITER TABLE SQUARE WITHFENCE
ANDCORRECTLY A DJUSTED
Fig. 13
FENCE
MITER TABLE
FRAMING ZEROCLEARANCE
SOUARE THROAT PLATE
VIEWOFMITER TABLE NOTSQUARE WITH
FENCE, A DJUS1MENTE A REREQUIRED
Fig. 14
FENCE
MITER TABLE
FRAMING ZERO CLEARANCE
SQUARE THROAT PLATE
VIEWOFMITER TABLENOTSQUARE WITH
FENCE, A DJUSTMENTS AREREQUIRED
Fig. 15
15