Craftsman 315.212120 Owner's Manual page 7

Blade Diameter 12in.
Blade Arbor 5/8 in.
No Load Speed 4000 RPM
Rating 120 Volts, 60 Hz-AC Only
Input 15 Amperes
Nat Weight 41 Ibs.
CuttingCapacity with Miter at 0°/Bevel 0°:
max widthx resultingheight 7-7/8 in. x 2-1/2 in.
Maximum CuttingCapacity with Miterat 45°/Bevel 0°:
max width x resulting height 5-1/2 in. x 2-1/2 in.
Maximum CuttingCapacity with Miter at 0°/Bevel 450:
max widthx resultingheight 7-7/8 in. x 1-3/4 in.
YourCompound Miter Saw has been shipped
completelyassembled except for the blade, miter lock
handle,and dust guide.
A WARNING: If any parts are missing,do not
operate this tool until the missing parts are
replaced. Failure to do so could result in possible
serious personal injury.
• Remove all loose parts from the carton. Separate
and check with the listof looseparts. See Figure2.
• Remove the packing materials from around your
seW.
• Carefully lift saw from the carton and place it on a
level work surface.This saw is heavy. To avoid
back injury, get help when needed.
• Do not discard the packing materials untilyou
have carefully inspectedthe sew, identifiedall
looseparts, and satisfactorilyoperated your new
SeW.
• Your sew has been shipped with the sew arm
locked in the down position.To release sew arm,
pushdown on top of sew arm and pull out the lock
pin. See Figure 4.
• Hand pressure should remain on the saw arm to
prevent sudden dse upon release of the lock pin.
• Examine all parts to make sure no breakage or
damage has occurredduring shipping.
If any parts are damaged or missing,do not attemptto
plug in the power cordand turn the switch on untilthe
damaged or missing parts are obtained and are
installedcorrectly.