Controlling Projectors - Sharp XG-P25X Operation Manual

Controlling Projectors

Connecting to a computer using the RS-232C Port
When the RS-232C IN port on the projector is connected to a computer with an RS-232C serial control cable
(cross type, sold separately), the computer can be used to control the projector and check the status of the
projector. See pages
70
Connect an RS-232C serial control cable (cross type, sold separately) to the serial port on the computer.
See page for recommended connection of an RS-232C serial control cable.
69
CAUTION
• Do not connect or disconnect an RS-232C cable to or from the computer while it is on. This may damage your computer.
• RS-232C function may not operate if your computer port is not correctly set up. Please refer to the operation manual of the computer for
details on setting up/installing the correct mouse driver.
Daisy chain connection
When controlling multiple projectors, or making stack projection using the accompanied Sharp Advanced
Presentation Software Professional Edition, projectors need to be daisy-chained.
1
Connect one end of the RS-232C cable to the RS-232C OUT port on the projector.
2
Connect the other end to the RS-232C IN port on another projector.
, and for details.
71 72
RS-232C serial control cable
AN-C10RS
(sold separately)
RS-232C serial control cable
1
AN-C10RS
(sold separately)
2
Computer
E-20