Selecting the Economy Mode
These functions allow you to reduce the power consumption. See page
Power Save Function
Function to control the quantity of projected light. Select "
decrease or increase brightness, fan noise and power consumption.
• "Power Save" mode is factory preset to "
• Even when selecting "
(Low Power Mode)" in "Power Save" mode, fan noise may increase if internal temperature rises
enough to activate the cooling function.
Monitor Out/RS-232C Off Function
This projector consumes power when using a monitor connected to the OUTPUT port for INPUT 1, 2 and a
computer connected to the RS-232C port. When not using these ports, "MNTR Out/RS232C" can be set to "
reduce standby power consumption.
CAUTION
• Set "MNTR Out/RS232C" to "
Automatic Power Shutoff Function
When no input signal is detected for more than 15 minutes, the projector will automatically shut off. The on-screen
message, "Power OFF in 5 min." will appear five minutes before the power is automatically turned off.
• "MNTR Out/RS232C" is factory preset to "
(Standard Mode)".
" when using the Sharp Advanced Presentation Software (supplied).
", and "Auto Power Off" is factory preset to "
for the procedure details.
38
(Low Power Mode)" or "
Quantity of light is 85 %.
Power consumption is about 350 W.
Quantity of light is 100 %.
Power consumption is 380 W.
Standby power for Monitor Out/RS-232C
connection turned off.
Monitor Out/RS-232C on
Power automatically shuts off after about 15
minutes of no signal input.
Automatic Power Shutoff disabled.
".
(Standard Mode)" to
" to
E-50