Adjusting The Projection Distance - Sharp XG-P25X Operation Manual

Adjusting the Projection Distance

Position the projector perpendicular to the screen with all feet flat and level to achieve an optimal image.
Move the projector forward or backward if the edges of the image are distorted.
• The projector lens should be centered in the middle of the screen. If the lens center is not perpendicular to the screen, the image will be
distorted, making viewing difficult.
• Position the screen so that it is not in direct sunlight or room light. Light falling directly onto the screen washes out colors, making viewing
difficult. Close the curtains and dim the lights when setting up the screen in a sunny or bright room.
• A polarizing screen cannot be used with this projector.
Two optional lenses from Sharp are also available for specialized application. Please see your local Sharp Authorized
LCD Projector Dealer to details on all the lenses. (Refer to the lens operation manual when attaching a lens.) Also,
be sure to have service personnel install the AN-P9MX and AN-P48EZ optional lenses.
Throw Distance
The graph below is for 100 inches (254 cm) screen with 4:3 normal mode.
Screen
AN-P9MX
5 11 (1.8 m)
Throw distance ratio 1:0.9
5
Standard Setup (Front Projection)
Place the projector at the required distance from the screen according to the
desired picture size. (See pages
• Two optional lenses from Sharp are available for specialized application. Please see
your local Sharp Authorized LCD Projector Dealer for details on all the lenses.
NORMAL Mode (4:3)
4
: Screen size and Picture size (4:3)
E-25
Standard
12 1 –15 7 (3.7–4.8 m)
Throw distance ratio 1:1.8–2.4
10 15
to .)
27 29
3
20 25
STRETCH Mode (16:9)
16
9
4
: Screen size and Picture size (16:9)
: Signal mask area
AN-P48EZ
30 10 –40 4 (9.4–12.3 m)
Throw distance ratio 1:4.6–6.1
30 35
3
40 (ft)
X
H
L