Sharp XG-P25X Operation Manual page 62

Using Extended Functionality Features
Stack Projection
For brighter images, two projectors can be stacked using the Stack Setting function.
Basic
Computer
Below are the steps for making a stack projection as shown in the diagram above.
1
Set the "Stack Setting" of Projector 1 to "Master".
(See page
52
2
Set the "Stack Setting" of Projector 2 to "Slave".
(See page
52
3
Select the same RS-232C transmission speed for both Projector 1 and Projector 2.
(See page
53
4
Adjust the "Set Inputs" setting as the table below.
(See page
53
Projector 1 (Master)
Set Inputs
ON
INPUT1
INPUT2 OFF
INPUT3 OFF
INPUT4 OFF
INPUT5 OFF
Set input terminals you will use to "ON".
Set input terminals you will not use to "OFF".
E-59
Projector 1
RGB cable
INPUT1
OUTPUT
RGB cable
INPUT1
Projector 2
for details.)
for details.)
for details.)
for details.)
Projector 2 (Slave)
Set Inputs
INPUT1 ON
INPUT2 OFF
INPUT3 OFF
INPUT4 OFF
INPUT5 OFF
Stack Setting
Master
RS-232C OUT
RS-232C cable
Stack Setting
RS-232C IN
Slave