Controlling The Projector Using A Computer - Sharp PG-A10X Operation Manual

Connecting the Projector to Other Devices

Controlling the Projector Using a Computer

Connecting to a
Computer Using a DIN-D-
sub RS-232C Adaptor
and an RS-232C Serial
Control Cable
When the RS-232C terminal on the projector is
connected to a computer with a DIN-D-sub RS-
232C adaptor and an RS-232C serial control
cable (cross type, sold separately), the com-
puter can be used to control the projector and
check the status of the projector. See page
for details.
1
Connect the supplied DIN-D-sub
RS-232C adaptor to an RS-232C
serial control cable (sold sepa-
rately).
2
Use the above cables to connect
the projector and the computer.
Note
• Do not connect or disconnect an RS-232C
serial control cable to or from the computer
while it is on. This may damage your com-
puter.
• The RS-232C function may not operate if
your computer terminal is not correctly set
up. Refer to the operation manual of the
computer for details.
• See page
60
serial control cable.
-20 -20
Downloaded from: http://www.usersmanualguide.com/
for connection of an RS-232C
Supplied
accessory
Optional
cable
Computer
61
To RS-232C terminal
DIN-D-sub
RS-232C adaptor
RS-232C serial control cable
Type: AN-C10RS (32'10" (10.0 m))
DIN-D-sub
RS-232C
adaptor
RS-232C serial
control cable
(sold separately)