Aerial Connection; Remote Control Sensor Connection - Sharp HT-CN300W Operation Manual

The speaker terminals on the main unit, the tube and plugs of the speaker lead, and
speaker labels are distinguished by colour.
Connect the speaker and the unit by matching the colours.
Connect the speaker wires to the speakers first, then to the unit.
Speaker
Label
Recess
Black Red
Tube
Main unit
Label
Speaker plug
Caution:
z Only the supplied speakers should be used with this unit.
z Make sure to connect the speakers after unplugging the unit.
z Do not mistake
and , and right and left terminals of the speaker leads.
z Do not let the bare speaker wires touch each
other.
z Do not stand or sit on the speakers. You may be injured.
z Insert the speaker plug fully with the rising side facing up.
z Hold the speaker plug when removing it from the unit. Pulling the lead may cause
breakage.

Aerial connection

Connect the FM/AM loop aerial to
the ANTENNA socket.
Position the FM aerial wire and rotate the AM loop aerial for optimum reception.
Place the AM loop aerial on a shelf, or attach it to a stand or on a wall with screws
(not supplied).
Notes:
z Placing the aerial on the unit, or near the AC power lead or the remote sensor may
cause noise pickup. Place the aerial away from the unit for better reception.
z Do not connect the attached FM aerial to an external FM aerial. Otherwise, trouble
may occur.
Installing the AM loop aerial:
Plug in with the rising
side facing up.

Remote control sensor connection

Connect the plug of the remote
control sensor and push the plug
cover until it clicks.
Removing the remote control sensor:
Push the upper and lower sides of the plug cover and take the
plug off the unit to disconnect the remote control sensor.
Caution:
z Hold the connection plug of the remote control sensor when removing it from the
unit. Pulling the lead may cause breakage.
z Make sure of the top and bottom of the plug when plugging in the remote control
sensor.
< Assembling > < Attaching to the wall >
Wall
Plug Plug cover
02/7/11 HT-CN300W_A_2.fm
HT-CN300W
Screws
(not supplied)
Push
Push
8