Sharp HT-CN300W Operation Manual page 22

Memorising the remote control buttons (continued)
HT-CN300W
Memorising operations in the Memory 1 buttons for other equipment:
Set the MEMORY 1/2 selector switch to MEMORY 1 and perform steps 2 - 6 in
"Memorising operations in the Memory 2 buttons for other equipment" (see page 20).
Note:
If a new function is memorised, the default operation on the button will be cleared.
Using the supplied labels:
Main features are already printed on the labels. Write in other operations as you
prefer.
Memorising operations in the operation buttons for other equipment:
1 Move the LEARN/TRANSMIT selector switch to LEARN.
2 Press down the desired button on the remote control for 2 seconds or more.
3 Perform steps 4 - 6 in "Memorising operations in the Memory 2 buttons for other
equipment" (see page 20).
21
„ Initialising the remote control buttons
You can delete memorised functions and restore the buttons to the factory settings.
1
Move the LEARN/TRANSMIT selector switch to LEARN.
The red learn indicator will light up. Though the red and green learn indicators
light up alternately after approx. 15 seconds, you can go on to the next step.
2
Press the ON/ (STAND-BY) and CLEAR buttons simultaneously
for more than 3 seconds.
Initialisation is completed when the red and green learn indicators light up
alternately and then the red learn indicator lights up.
3
Move the LEARN/TRANSMIT selector switch to TRANSMIT.
z You can use the remote control.
z Operation buttons and Memory 1 buttons for other equipment will return to the
Registrable buttons
factory setting.
Caution:
You cannot initialise only one button. If initialisation is performed, all the stored
functions will be cleared.
Lights up Alternately light up
Alternately light up
Lights up
02/7/11 HT-CN300W_A_3.fm
Goes off