Display Control; Sound Control - Sharp HT-CN300W Operation Manual

Display control

HT-CN300W
„ To change the display brightness (2 levels)
You can switch the brightness of the main unit display by pressing the DIMMER
button.
Dimmed (Dimmer mode)
„ TV screen display
By pressing the DISPLAY button whilst in the DVD or VIDEO mode, you can check
the status or setting on the TV screen.
Example:
Caution:
This unit can display on the TV its current speaker and mode settings when in the
DVD or VIDEO mode, but not if connected to the TV via an S-video cable. This
function is only available via the Video cable connection.
23
Brightened
TV screen display

Sound control

„ Volume control
Press the VOLUME button to increase the volume and the VOLUME
decreasing.
Main unit
TV screen
„ Bass control
When the X-BASS button is pressed, the unit will enter the extra bass mode which
emphasises the bass frequencies. To cancel the extra bass mode, press the X-BASS
button.
Main unit
TV screen
Bass frequencies are
emphasised.
„ Equaliser
When the EQ button is pressed, the current mode setting will be displayed. To
change to a different mode, press the EQ button repeatedly until the desired sound
mode appears.
FLAT The sound is not modified.
ROCK Bass and treble are emphasised.
POPS Bass and treble are slightly emphasised.
JAZZ Treble is cut a little.
CLASSIC Treble is reduced a lot.
VOCAL Vocals (midrange tones) are emphasised.
Note:
Bass control and equaliser are enabled only when the sound mode is set to
"STEREO" or "VIRTUAL" (see page 26).
02/7/11 HT-CN300W_A_4.fm
button for
.....
0 1 2 29 30 MAXIMUM
Cancelled.