Special Mode Adjustment; Checking The Input Signal - Sharp Notevision XG-C40XE Operation Manual

Computer Image Adjustments (INPUT 1 or 2 mode Only)
Projector
2, 3, 4
(GUI) On-screen Display
Projector
(GUI) On-screen Display
33
Remote control
1, 6
5
Remote control
1, 4
2, 3

Special Mode Adjustment

Ordinarily, the type of input signal is detected and the
correct resolution mode is automatically selected.
However, for some signals, the optimal resolution mode
in "Special Modes" on the "Fine Sync" menu screen
may need to be selected to match the computer display
mode.
(Slide the MOUSE/ADJUSTMENT switch
on the remote control to the ADJ. position.)
1 Press MENU.
2 Press ß/© to select "Fine Sync".
3 Press ∂/ƒ to select "Special Modes", and then
press ©.
4 Press ∂/ƒ to select the optimal resolution mode.
5 Press ENTER to save the setting.
6 To exit from the GUI, press MENU.
• Avoid displaying computer patterns which repeat every
other line (horizontal stripes). (Flickering may occur, making
the image hard to see.)
• When inputting DTV 480P signals, select "480P" in step
above.

Checking the Input Signal

This function allows you to check the current input signal
information.
(Slide the MOUSE/ADJUSTMENT switch
on the remote control to the ADJ. position.)
1 Press MENU.
2 Press ß/© to select "Fine Sync".
3 Press ∂/ƒ to select "Signal Info" to display the
current input signal.
4 To exit from the GUI, press MENU.
MOUSE ADJ.
4
MOUSE ADJ.