Sharp Notevision XG-C40XE Operation Manual page 22

Basic Operations
4
3
EXAMPLE
5
INPUT 1 Mode
d
INPUT 4
(S-VIDEO) Mode
6
7
8
19
6
7
8
5
INPUT 2 Mode
g
f
INPUT3
(VIDEO) Mode
s
3 Slide the zoom knob. The image can be adjusted
to the desired size within the zoom range.
4 Slide the focus knob until the image on the screen
becomes clear.
5 Press INPUT to select the desired input mode.
Press INPUT again to change the mode.
• When no signal is being received, "NO SIGNAL" will be
displayed. When a signal that the projector is not preset
to receive is being received, "NOT REG." will be displayed.
6 Press VOLUME
/
7 Press MUTE to temporarily turn off the sound.
Press MUTE again to turn the sound back on.
8 Press POWER OFF.
Press POWER OFF again while the message is
displayed.
• If you accidentally pressed POWER OFF and do not want
to turn off the power, wait until the power off screen
disappears.
• When POWER OFF is pressed twice, the POWER indicator
will illuminate red and the cooling fan will run for about 90
seconds. The projector will then enter standby mode.
• Wait until the cooling fan stops before disconnecting the
power cord.
• The power can be turned on again by pressing POWER
ON. When the power is turned on, the POWER indicator
and the LAMP REPLACEMENT indicator illuminate green.
• The POWER indicator flashes if the bottom filter cover is
not securely installed.
WARNING:
The cooling fan in this projector continues to run for about
90 seconds after the projector is turned off. During normal
operation, when turning the power off always use the
POWER OFF button on the projector or the remote
control. Ensure the cooling fan has stopped before
disconnecting the power cord.
DURING NORMAL OPERATION, NEVER TURN THE
PROJECTOR OFF BY DISCONNECTING THE POWER
CORD. FAILURE TO OBSERVE THIS WILL RESULT IN
PREMATURE LAMP FAILURE.
to adjust the volume.