Special Mode Adjustment; Checking The Input Signal - Sharp XG-V10XU Operation Manual

Adjusting the Computer Images (RGB menu only)
Projector
1, 6
2, 3, 4
5
(GUI) On-screen Display
Projector
1, 4
2, 3
(GUI) On-screen Display
Remote Control

Special Mode Adjustment

Ordinarily, the type of input signal is detected and the
correct resolution mode is automatically selected.
However, for some signals, the optimal resolution mode
in "Special Modes" on the "Fine Sync" menu screen
may need to be selected to match the computer display
mode.
1.2.3 4.5.6
• Avoid displaying computer patterns which repeat every
• When inputting DTV 480P or 1080i signals, select the

Checking the Input Signal

Remote Control
This function allows you to check the current input signal
information.
1.2.3 4.5.6
(Slide the MOUSE/ADJUSTMENT switch
on the remote control to the ADJ. position.)
1 Press MENU.
2 Press ß/© to select "Fine Sync".
3 Press ∂/ƒ to select "Special Modes", and then
press ©.
4 Press ∂/ƒ to select the optimal resolution mode.
5 Press ENTER to save the setting.
6 To exit from the GUI, press MENU.
other line (horizontal stripes). (Flickering may occur, making
the image hard to see.)
corresponding type of signal in step 4 above.
(Slide the MOUSE/ADJUSTMENT switch
on the remote control to the ADJ. position.)
1 Press MENU.
2 Press ß/© to select "Fine Sync".
3 Press ∂/ƒ to select "Signal Info" to display the
current input signal.
4 To exit from the GUI, press MENU.
MOUSE ADJ.
MOUSE ADJ.
E-48