Specifications; Troubleshooting - Sharp Plasmacluster IG-BL20E Operation Manual

SPECIFICATIONS

Model
Power supply
Fan Speed Adjustment
Power consumption(W)
Airflow volume(m /hour)
3
Applicable floor area(m
Ion density(ions/cm )
3
Cord Length(m)
Outer dimensions(mm)
Weight(kg)
* The applicable floor area for which an emitted airborne ion density of about 25,000 ions/cm
measured at a point near the center of the room (at a height of about 1.2m from the floor), during
operation at the HIGH mode when the main unit is placed near a wall.
*2 Ion count per cm blown into air at around the center of the room ( at a height of approx. .2m from the
3
floor) during operation at each airstream setting when the main unit is placed near the wall.
• The number of ions will vary according to the room conditions and operation mode.
Standby Power In order to operate the electrical circuits while the power plug is inserted in the wall outlet, this
product consumes about 0.8W of standby power.
For energy conservation, unplug the power cord when the unit is not in use.

TROUBLESHOOTING

Before calling for service, please review the TROUBLESHOOTING chart below.
The problem may not be a unit malfunctions.
Problem
Flashing
(red)
Flashing
(red)
Lighting
(orange)
Flashing
(red & green)
HIGH
)
2 *
25,000
*2
Flashing
(blue)
Flashing
(blue)
Flashing
(blue)
Flashing
(blue)
Flashing
(blue)
IG-BL20E
220-240V,50/60 Hz
MED
3 8.5
270 20
20
2,000
.8
392(W)x182(D)x500(H)
5.8
WHAT TO DO
•It's time to replace Plasmacluster Ion Generating
Unit.
Replace with a new Plasmacluster Ion Generat-
ing Unit. (See page E-7)
•Plasmacluster Ions are not released. Dust may block the filter,
clean the filter.(See page E-5)
If the lights are still flashing after cleaning filter, unplug and
contact the store you purchased or Sharp service center.
•Filter is getting dirty. Clean the filter.
After cleaning the filter, press FILTER RESET
Button for 3 seconds. (See page E-5)
•Confirm the Plasmacluster Ion Generating Unit is
set correct position, and press the Operation But-
ton to restart. (See page E-7)
•Failure
Unplug the power cord and contact the store you
purchased or Sharp service center.
E-8
LOW
5.5
56
7,000
can be
3