Mode Selection Button; Humidify And Clean Air Mode - Sharp Plasmacluster KC-6400E Operation Manual

OPERATION

Mode Selection Button

The operation mode can be switched, and the Indicator Light will turn on.
Clean Air
During operation

Humidify and Clean Air Mode

Use the Clean Air Mode and Humidify Mode together to quickly remove house dust floating
in the air as well as eliminates odour. (for fresh air and those of saturated ones.)
During Normal Use
Clean Air :
Humidify :
For Quiet Use at Bedtime, Etc.
Clean Air :
Humidify :
When Air is Dry
Clean Air :
Humidify :
About Automatic Humidify Mode
The Temperature/Humidity
Sensors control humidity
automatically in accordance
w i t h c h a n g e s i n r o o m
temperature.
* Depending on the size and dryness of your room, humidity
may not reach 55 - 65%. In such cases, it is recommended
to operate in "Humidify HIGH" Mode.
4 sensors (a *Dust Sensor and an Odour Sensor for detecting
AUTO
impurities in the air, and Temperature/Humidity Sensors for
detecting temperature and humidity) are used to automatically
AUTO
control airflow volume in accordance with the state of your room.
2 sensors (a *Dust Sensor and an Odour Sensor for detecting
AUTO
impurities in the air) are used to automatically control airflow
volume in accordance with the amount of impurities detected in
LOW
your room, while humidifying gently and quietly in "Humidify LOW"
Mode.
2 sensors (a *Dust Sensor and an Odour Sensor for detecting
AUTO
impurities in the air) are used to automatically control airflow
volume in accordance with the amount of impurities detected in
HIGH
your room, humidifying vigorously in "Humidify HIGH" Mode.
(Operation noise increases)
Humidify
During operation
Only KC-6500E is equipped with the Dust sensor.
*
When operating Clean Air
Mode and Humidify Mode
together, Humidify Mode
takes priority.
E-14