Filter Cleaning; Washable Active Carbon Filter Care - Sharp Plasmacluster KC-6400E Operation Manual

FILTER CLEANING

Care Cycle 2 months
Clean the top surface of the Washable Active
Carbon Filter lightly with a vacuum cleaner.

WASHABLE ACTIVE CARBON FILTER CARE

HAND WASH ONLY!
DO NOT TUMBLE DRY!
1
Fill a large container with warm
water, add a mild kitchen
detergent and stir.
Dilute as indicated on
the detergent container.
2
Allow the filter to soak approximately
10 minutes before washing.
If the filter surface is very
dirty, scrub with an old
toothbrush.
CAUTION
Handle with care to prevent damage
to the activated carbon particles.
3 Rinse thoroughly
with clean water.
CAUTION
If rinsing in a container, be sure to rinse 3 to 4 times
so that the odour is rinsed thoroughly from the filter.
4
Remove excess water.
The filter will be saturated
with water after rinsing. To
decrease drying time, wrap
the filter in an old thick towel
so that excess water can be
removed.
CAUTION
• Some carbon may adhere to the
towel, but it is harmless.
• It is not allowed to wring out the
filter.
Washable Active Carbon Filter
(The illustration has used "KC-6500E" )
2 months
Care Cycle
5
• The wet filter is heavy. Fix it securely for
• The filter takes longer to dry in winter,
• Dry the filter outdoors in a well ventilated
• Make sure that the activated carbon has
• Let the filter dry thoroughly.
6
Towel
E-17
Dry the filter outdoors if pos-
sible in a well ventilated
area.
CAUTION
drying to make sure it does not fall down.
on rainy days. Wash it on a day when
the weather is good and dry it in the sun.
Move it indoors at night to prevent freez-
ing.
area. If dried indoors, the water dripping
off the filter may soil your floor.
not shifted to one side inside the filter. If
it has, distribute it evenly with your fin-
gers.
If used while the filter is still moist, then
the air that is exhausted from the main
unit will have an odour. It may take 1 or
2 days to dry.
Reinstalling the Filters.
Reinstall the filters as shown on
Page E-10,11.