Operation Start/Stop; Auto Mode; Clean Ion Shower Mode; Plasmacluster Ion Spot Mode - Sharp FP-J60TA Operation Manual

OPERATION
START/STOP
START
♪ ♪ ♪

AUTO MODE

The fan speed is automatically controlled
depending on the 3 detection. (Dust(sensitive) /
Odor / Light)
NOTE
• Front Display, Cleanliness Monitor automatically
switch ON and OFF based on room brightness.
(When light control is set to "Auto". (page 9))

CLEAN ION SHOWER MODE

The unit releases Plasmacluster ions with strong
airfl ow and collects dusts while decreasing static
electricity for 10 minutes. After that, the DUST
sensor sensitivity is automatically increased
and quickly detects impurities and clean the air
powerfully for 50 minutes.
NOTE
• When the operation fi nishes after 60 minutes, the
unit will return to the prior operation mode. It is
able to change the other mode during this mode.
• The Plasmacluster Ion can not be turned "OFF".
STOP
♪ ♪ ♪ ♪ ♪
♪
♪
PLASMACLUSTER ION
SPOT MODE
Use this mode when you want to remove adhering
odor, germs, and other substances from cloths,
sofas and curtains.
♪
NOTE
• Emits highdensity Plasmacluster Ions only in the
forward direction.
• Discharges stronger air for 8 hours. When the
operation fi nishes, the main unit will return to its
prior operation mode.
• The Plasmacluster Ion can not be turned "OFF".

SELECTING MODE

♪
SLEEP :
The main unit will operate quietly, and the fan
speed is automatically switched depending on
the amount of impurities in the air.
The Front Display and Cleanliness Monitor go
off automatically.
POLLEN :
The DUST SENSOR sensitivity is automatically
increased and quickly detects impurities such
as dust and pollen and clean the air powerfully.
EN-7
Adjust Front Louver manually.
♪ ♪
POLLEN
♪
SLEEP
♪
LOW
♪
MED
♪
MAX