Playing Dolby Digital (5.1 Channel), Dts Or Mpeg Audio - Sharp DV-NC70W Operation Manual

Playing Dolby Digital (5.1 channel), DTS or MPEG audio

Connecting an amplifier with a Dolby Digital/DTS/MPEG Audio digital surround processor or a Dolby Digital/
DTS/MPEG Audio surround processor to your Product's coaxial digital jack provides richer and more powerful
audio play.
Connection to a processor or amplifier with a coaxial digital input jack
You can make this connection
using a coaxial digital cable .
This Product
Digital Connection to an MD to Record a CD
Some Audio CDs and VIDEO CDs have a short silent section between musical tracks. When sound from discs
such as these is digitally recorded by connecting the Product directly to a digital recorder (such as an MD player),
the music may be recorded continuously and track numbers may be lost.
Digital Connection to Audio Equipment or MD Player without a Dolby Digital Decoder
• Audio CD or VIDEO CD
Play the disc as you normally would, with the audio mode set to "L+R" (see page 89). With a digital
connection, audio of a disc recorded with DTS sounds abnormal in this case.
• DVD
With a digital connection, audio cannot be produced from a DVD recorded with Dolby Digital (5.1 channel),
Dolby Surround (Pro Logic), DTS or MPEG Audio, so you should use an analogue connection to play such
discs. Discs with linear PCM audio should play normally.
• This connection is not possible if the processor or amplifier to which you want to connect does not have a coaxial
digital input jack.
Required cable
Coaxial digital cable (commercially available)
DVD OUT
LINE OUT 2
COMPONENT
DIGITAL
Y
AUDIO
P S-VIDEO
B
( C )
B
P
R
( C )
R
To coaxial
DIGITAL OUT jack
Coaxial digital cable
(commercially available)
To coaxial
digital input jack
DIGITAL IN
COAXIAL
Audio equipment
DVD Audio Connections
DVD/VCR VCR
LINE OUT 1 LINE IN 1 ANTENNA IN
R R
AUDIO AUDIO
L L
R
VIDEO VIDEO
AUDIO
L
RF OUT
17
GB