Tv Programme Recording; Cassette Erase Protection; Recording A Tv Programme; To Watch Another Tv Programme While Recording - Sharp DV-NC70W Operation Manual

TV Programme Recording

Cassette Erase Protection

A cassette has a removable tab to prevent accidental
,
PAL SECAM
erasure of recorded material. Removing the tab prevents recording.
To record on a video cassette with the tab removed, place adhesive
tape over the tab opening.

Recording a TV Programme

Preparation
Press OPERATE. Then move the VCR/DVD CHANGE Switch to
VCR.
Ensure the Video channel is selected on the TV.
1
Insert the cassette, making sure the erasure protection hole is
covered.
2
Select the channel position you wish to record with CH ' / ".
3
Select the SP (Standard Play), EP (Extended Play) or LP (Long
Play) recording speed with TAPE SPEED on the Remote ("SP",
"EP" or "LP" will light up on the VCR Front Panel display.) SP
(Standard Play) gives the best picture quality, EP (Extended
Play) gives the triple recording time and LP (Long Play) gives
the double recording time.
If the COLOUR mode is set to "AUTO" or "MESECAM", when a
SECAM signal is received and the EP mode is selected, the Product
will automatically change the EP mode to LP mode.
4
Press Æ Æ Æ Æ Æ REC. (If the erasure protection hole is uncovered, the
cassette will be ejected.) To pause during recording, press
âPAUSE/STILL. To resume recording, press âPAUSE/STILL
again.
5
To stop recording, press ËSTOP.
The pause mode disengages automatically after about 5 minutes, and
the Product enters stop mode.
To record audio and video from an external source through the
AUDIO/VIDEO terminal on the rear of the Product, press INPUT SELECT
on the Remote to select the AV channel position situated between the
last channel and first channel. (When the AV position is selected, "L1"
or "L2" is displayed where a channel position number is usually
displayed.)
If the TV signals are weak and the picture changes to monochrome,
set the strict colour mode on the MODE selection screen. (See "Mode
Selection" on page 23.) Normally, the colour mode should be set to
"AUTO".
To Watch Another TV Programme While
Recording
After steps 1 to 4 have been completed, select the programme you
wish to view using the TV tuner. At the end of the tape, your Product
will automatically stop recording, rewind the tape, eject it and then turn
off the power. If a DVD is being played back, the power will not turn off.
62
GB
ERASURE
PROTECTION TAB
DV- NC70W
DV- NC70
DV- NC70X
TIMER
OPERATE
EJECT
ON/OFF
ON VCR/DVD VCR MENU
DISPLAY
SCREEN SELECTOR DVD SETUP
FUNCTION PROG/ OPEN/
ANGLE
CONTROL REPEAT CLOSE
TITLE
DVD MENU
CLEAR
SET
RETURN ENTER
ZERO BACK
SKIP SEARCH
AM/PM INPUT SELECT VCR DVD
/
REV FWD
PLAY
REC
PAUSE/STILL
STOP
TAPE DPSS
SPEED SKIP SLOW
AUDIO
CH
OUTPUT
VCR DVD
VCR/DVD COMBINATION
G-CODE
PROG