Audio Setting; Setting The Compression (Dolby Digital Output Level) - Sharp DV-NC70W Operation Manual

DVD Setup

AUDIO Setting

COMPRESSION ............ Use this setting for increasing the average
DIGITAL .................. Use this setting for specifying the type of
CINEMA VOICE ............. Use the setting for raising the sound of the
Setting the COMPRESSION
(Dolby Digital output level)
When Dolby Digital is used to record the audio on a DVD disc, the
average overall volume level of the audio is relatively lower than that
produced by a VIDEO CD/Audio CD. This is to provide the widest
possible dynamic range. To counteract this, this product automatically
raises the overall average volume level of a disc recorded using Dolby
Digital to a level that is similar to that of a VIDEO CD/Audio CD.
DVD
Dolby Digital audio
VIDEO CDs
Audio CDs
• OFF .............. Audio level recorded on disc is played back without
modification.
• ON ............... Dolby Digital average audio level is increased so it
sounds similar to that of a VIDEO CD/Audio CD.
Preparation
See Preparing to Watching a VCR or a DVD on page 18.
1
Press DVD SETUP to display the SETUP screen.
2
Use ' or " to select the "
44
GB
volume of Dolby Digital audio when playing
a DVD.
digital output when playing a disc.
center speaker to make the voices in a
movie easier to hear.
COMPRESSION:
OFF
• Audio level the same
• Low audio level
AUDIO" and then press ENTER.
AUDIO
COMPRESSION OFF
D I G I T A L BITSTREAM
MPEG BITSTREAM
CINEMA VOICE OFF
SELECT
ENTER RETURN
ENTER
COMPRESSION:
ON
as audio CD, etc.
DV- NC70W
DV- NC70
DV- NC70X
TIMER
OPERATE
EJECT
ON/OFF
ON VCR/DVD VCR MENU
DISPLAY
SCREEN SELECTOR DVD SETUP
FUNCTION PROG/ OPEN/
ANGLE
CONTROL REPEAT CLOSE
TITLE
DVD MENU
CLEAR SET
RETURN ENTER
ZERO BACK
SKIP SEARCH
AM/PM INPUT SELECT VCR DVD
/
REV FWD
PLAY
REC
PAUSE/STILL
STOP
TAPE DPSS
SLOW
SPEED SKIP
AUDIO
CH
OUTPUT
VCR DVD
VCR/DVD COMBINATION
G-CODE
PROG