Timer Operation - Sharp AY-AP18GR Operation Manual

TIMER OPERATION

TIMER OFF
The unit will turn off automatically according to your setting.
Timer duration can be set from a minimum half an hour (30 minutes) to a maximum
of 12 hours.
Up to 9.5 hours, you can set in half-hour (30-minute) increments, and from 10 to 12
hours, in 1-hour increments.
Display shown when you
set the unit to ture off 2.5
hours later.
TIPS ABOUT TIMER OFF OPERATION
When the TIMER OFF is set, the temperature
setting is automatically adjusted to prevent
the room from becoming excessively cold
while you sleep. (Auto Sleep function)
COOL/DRY MODE:
• One hour after the timer operation begins,
the temperature setting rises 1°C higher
than the original temperature setting.
HEAT MODE:
• One hour after the timer operation begins,
the temperature setting drops 3°C lower
than the original temperature setting.
Point the remote control at the signal receiver win-
dow on the unit.
1
Press the TIMER OFF (
the time as desired.
• The time setting will change as you press the
button as follows,
0.5h 1.0h
Hold the button down to speed through the
settings.
• The orange TIMER lamp (
1
will light.
• The unit will generate a beep when it re-
ceives the signal.
• The time setting will count down to show the
remaining time.
TO CANCEL TIMER
Press the CANCEL button.
• The orange
TIMER lamp
(
unit will turn
off.
TO CHANGE TIMER SETTING
Press the TIMER button which you wish to
change, (TIMER OFF or TIMER ON) and
change the time setting.
E-10
) button and set
1.5h 10h 11h
) on the unit
) on the
12h