Sharp AE-X127J Operation Manual page 33

As a part of our policy of continuous improvement, SHARP reserves the right to make design and specification changes
for product improvement without prior notice. The performance specification figures indicated are nominal values of
production units. There may be some deviations from these values in individual units.
General
Power source: AC 11 O/l 27/220/230-240 V,
Power consumption: 65 W
Width; 270 mm (1 O-5/8")
Dimensions:
Height; 300 mm (1 l-1 3/l 6")
Depth; 359.5 mm (14-3/l 6")
5.0 kg (11.0 Ibs.)
Weight:
section
PMPO; 160 W (total)
Output power:
MPO; 33 W (16.5 W + 16.5 W)
(10 % T.H.D.)
RMS; 20 W (10 W + 10 W)
(10 % T.H.D.)
Output terminals: Speakers; 8 ohms
Headphones; 16-50 ohms
(recommended; 32 ohms)
Video/Auxiliary (audio signal);
Input terminals:
245 mV/47 kohms
Frequency range: FM; 88 - 108 MHz
AM; 531 - 1,602 kHz
Reset the microcomputer by performing the following
procedure for the cases shown below:
memory contents, or
l
To erase all of the stored
If the display does not function properly, or
l
The unit does not operate properly.
Set the ON/STAND-BY switch to STAND-BY.
2
Press and hold down the VOLUMEv button, the m / w
button and the ON/STAND-BY switch all at the same time.
Hold them for at least 1 second.
Dirty heads, capstans or pinch rollers can cause poor sound
and tape jams. Clean these parts with a cotton swab moist-
ened with commercial head/pinch roller cleaner or isopropyl
alcohol.
After long use, the deck's heads and capstans may become
magnetised, causing poor sound. Demagnetise these parts
once every 30 hours of playing/recording time by using a
commercial tape head demagnetiser. Read the demagne-
tiser's instructions carefully before use.
soap solution, then wipe with a dry cloth.
cals.
Frequency response:
Signal/noise ratio: 55 dB (TAPE 1, playback)
50 dB (TAPE 2, recording/
Wow and flutter: 0.15
Compact disc player secfion
3-disc multi-play compact disc
Type:
player
Signal readout: Non-contact, 3-beam semi-
conductor laser pickup
D/A converter: l-bit D/A converter
Frequency response: 20 - 20,000 Hz
Dynamic range: 90 dB (1 kHz)
l
Speaker section
Type:
and super tweeter]
Maximum input
20 w
power:
8 ohms
Impedance:
Dimensions: Width; 180 mm (7-l/8")
Height; 300 mm (ll-13/16")
Depth; 214 mm (8-7/l 6")
Weight:
2.4 kg (5.3 Ibs.)/each
1 6
playback)
(WRMS)